Tech-source GFX 400 Series Uživatelský manuál Strana 17

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 60
  • Tabulka s obsahem
  • ŘEŠENÍ PROBLÉMŮ
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 16
Chapter 3 Software Installation
3-5
Please see the man page on mkoconfig for a detailed
description.
The next two sections describe two methods of using
mkoconfig to configure the GFX 400 card.
3.4.1 Interactive Configuration
mkoconfig has an interactive menu-style interface (See Figure
3.1). To use this program to configure your GFX 400 card, type:
prompt# mkoconfig -i
NOTE: If X Windows is running on the GFX 400 card(s) to be
configured, please exit out of it before running mkoconfig.
Failure to do so could result in a corrupted screen for the
remainder of the X Window session.
The GFX 400 device(s) will be listed in the left column of the
configuration screen displayed by mkoconfig. (See Figure
3.1).
A description of the commands is as follows:
Up/Down Arrow selects the desired graphics
device to modify
Left/Right Arrow selects the parameter to modify
(e.g. resolution, bit-depth, or
sync)
Space Bar modifies the parameter for the
selected graphics device (will
bring up a menu when
applicable)
Zobrazit stránku 16
1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 59 60

Komentáře k této Příručce

Žádné komentáře