Tech-source Raptor OpenWindows for Solaris Uživatelský manuál stáhnout pdf (Strana 18)

Raptor OpenWindows for Solaris Installation and Reference Manual

3-2

• OpenWindows Version 3.5 or higher has already been

installed on the system. This is typically bundled with the

OS.

• At least 2MB of disk space is available in /usr and /.

• One or more of the cards listed in Section 3.1 are presently

installed in the workstation.

3.3 Installing I-Class Card Driver

Software

The following are step-by-step instructions for installing the

Raptor OpenWindows for Solaris Software from a CD-ROM.

1. Install a Raptor card in the computer as described in

Chapter 2.

2. Boot the computer with the -r (reconfiguration) option.

To do this on an UltraSPARC workstation, perform the

following steps:

• Power ON the computer.

• Wait until you see boot messages displaying on the

screen, then press and hold the Stop (L1) key, and

then press the A key.

• At the ok prompt, type boot –r.

3. After the system comes up, log in as root.

4. Insert the CD-ROM labeled “Raptor OpenWindows for

Solaris Software” into the drive.

5. If /cdrom/cdrom0 exists, the CD-ROM was

automatically mounted. Change directories to the CD-

ROM by typing the following:

prompt# cd /cdrom/cdrom0/I-Class

If /cdrom/cdrom0 does not exist, mount the CD-ROM

by typing the following:

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 67 68

Žádné komentáře

Tech-source Raptor OpenWindows for Solaris Uživatelský manuál Strana 18